Configuration

Tous les paramètres
?
Redémarrage
RS2 Disclaimer

WARNING:

Please note that you are enabling this device to turn on or off electrical outlet(s) on RS2 unit(s).

Also note that the acceptance of these terms is saved in the XML configuration file on this device. If this file is used to configure another unit, then the acceptance of these conditions will carry over to that device as well.

There are no warranties, express or implied by this action, by the operation of law or otherwise, of enabling this feature. GEIST DISCLAIMS ALL IMPLIED WARRANTIES OF MERCHANTABILITY, SATISFACTION, AND FITNESS FOR A PARTICULAR PURPOSE.

Geist express warranties will not be enlarged, diminished, or affected by and no obligation or liability will arise out of Geist rendering of technical or other advice or service in connection with the alarms being set on the RS2.

The foregoing warranties and remedies are exclusive and in lieu of all other warranties and remedies. THERE ARE NO WARRANTIES SET FORTH ABOVE--ONLY THE EXCLUSION OF ALL IMPLIED WARRANTIES.

Geist warranties extend only to purchaser and are not extended to any third parties. IN NO EVENT SHALL GEIST, ITS OFFICERS, DIRECTORS, AFFILIATES OR EMPLOYEES BE LIABLE FOR ANY FORM OF INDIRECT, SPECIAL, CONSEQUENTIAL OR PUNITIVE DAMAGES, ARISING OUT OF THE USE, SERVICE OR INSTALLATION, OF THE PRODUCTS, WHETHER SUCH DAMAGES ARISE IN CONTRACT OR TORT, IRRESPECTIVE OF FAULT, NEGLIGENCE OR STRICT LIABILITY OR WHETHER GEIST HAS BEEN ADVISED IN ADVANCE OF THE POSSIBILITY OF SUCH DAMAGES. SPECIFICALLY, GEIST IS NOT LIABLE FOR ANY COSTS, SUCH AS LOST OF PROFITS OR REVENUE, LOSS OF EQUIPMENT, LOSS OF USE OF EQUIPMENT, LOSS OF SOFTWARE, LOST OF DATA, COST OF SUBSTITUENTS, CLAIMS BY THIRD PARTIES, OR OTHERWISE.

No salesman, employee or agent of Geist is authorized to add or vary the terms of this warranty. Warranty terms may be modified if at all, only in writing signed by a Geist officer and legal department.

View the Geist Warranty at: www.geistglobal.com/support/power/technical-information/power-firmware/power-warranty

Disabled

I Accept

 

Horloge système, paramétrée sur GMT?
Méthode de paramétrage de l'horloge:
GMT to local, (+/-)hh:mm
Mois
Jour
Année
(aa)
Heure
(0-23)
Minute
(0-59)
Seconde
(0-59)
Serveur NTP principal

17.253.84.253
Serveur NTP secondaire

129.6.15.28
Sync. sur le temps du serveur NTP (secondes)
Heure d'été?
L'heure d'été est DESACTIVEE
Activer l'heure d'été:
Début de l'heure d'été:
en
à
Fin de l'heure d'été:
en
à
Configuration du nom et du mot de passe
REMARQUE 1 : si le compte possède déjà un mot de passe, laisser le champ Ancien mot de passe vide équivaut à n'effectuer aucune modification à ce compte.
REMARQUE 2 : le mot de passe Administrateur peut être utilisé dans le champ Ancien mot de passe de n'importe quel compte.
REMARQUE 3 : si le champ Nouveau mot de passe est laissé vide, le champ Nom du compte doit également être vide.
REMARQUE 4 : si le champ Nouveau mot de passe n'est pas vide, le champ Nom du compte ne doit pas être vide.
Nom du compte Administrateur?
Ancien mot de passe
Nouveau mot de passe
Confirmer le nouveau mot de passe
(encore, pour confirmer)
Attention : conservez votre mot de passe. Un mot de passe perdu peut prendre 48 heures pour être récupéré.
Contrôler le nom du compte?
Ancien mot de passe
Nouveau mot de passe
Confirmer le nouveau mot de passe
(encore, pour confirmer)
Attention : conservez votre mot de passe. Un mot de passe perdu peut prendre 48 heures pour être récupéré.
Afficher le nom du compte uniquement?
Ancien mot de passe
Nouveau mot de passe
Confirmer le nouveau mot de passe
(encore, pour confirmer)
Attention : conservez votre mot de passe. Un mot de passe perdu peut prendre 48 heures pour être récupéré.
Info Admin?
Nom du contact:
E-mail du contact:
(sysContact)
Contact Téléphone:
Emplacement du périphérique:
(sysLocation)
Description du périphérique:
(sysName)
Fichier XML de configuration enregistré?
Certificat SSL et clé privée?
Le certificat et la clé privée SSL sont NON VALIDE
Fichier de certificat SSL:
Fichier clé privée SSL:
Charger le firmware système?
Fichier de package firmware:

Le chargement du firmware peut prendre quelques minutes. Veuillez attendre la réponse du navigateur.
English | Français | 中文 | Deutsch | 日本語 | Español